Auto Inspections in Universal City 78148

B & S AUTOMOTIVE > REPAIR SERVICES > INSPECTIONS AND EMISSIONS

Some states require regular safety inspections and/or emissions inspections on cars and trucks. At B & S Automotive, we are well-equipped and trained to perform these inspections. Our technicians can also perform multi-point inspections on your vehicles as needed.

These are some of the inspection services we offer.

TX State Certified Emissions Repair Facility
A state certified emissions repair facility is a privately owned motor vehicle repair facility, licensed to repair emission-related failures. The repair facility must employ a CERT (Certified Emissions Repair Technician) who has passed a state-required training program. B & S Automotive is a TX state certified emissions repair facility. Contact us at 210-659-4263 or visit us today for emission-related repairs and services.

TX State Inspection Station
TX state inspection stations are privately owned, but government certified, inspection stations throughout TX. B & S Automotive is a TX state inspection station. For your state inspection needs visit or call our auto shop at 210-659-4263.

To learn more about our Inspection and Emission services, call us at 210-659-4263 or request a quote by clicking below:

Request Quote

hours

Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday

8:00AM - 5:00PM
8:00AM - 5:00PM
8:00AM - 5:00PM
8:00AM - 5:00PM
8:00AM - 5:00PM
Closed
Closed
Contact us

B & S Automotive

201 W Aviation Blvd
Universal City, TX 78148
210-659-4263
Email Us | Get Directions
Vehicle tips
- According to recent studies, 5 percent of all motor vehicle fatalities are clearly caused by automobile maintenance neglect.
- The cooling system should be completely flushed and refilled about every 24 months. The level, condition, and concentration of coolant should be checked. (A 50/50 mix of anti-freeze and water is usually recommended.)
- Never remove the radiator cap until the engine has thoroughly cooled. The tightness and condition of drive belts, clamps and hoses should be checked by a pro.
- Change your oil and oil filter as specified in your manual, or more often (every 3,000 miles) if you make frequent short jaunts, extended trips with lots of luggage or tow a trailer.
- Replace other filters (air, fuel, PCV, etc.) as recommended, or more often in dusty conditions. Get engine drivability problems (hard stops, rough idling, stalling, diminished power, etc.) corrected at a good shop.
- A dirty windshield causes eye fatigue and can pose a safety hazard. Replace worn blades and get plenty of windshield washer solvent.
- Have your tires rotated about every 5,000 miles. Check tire pressures once a month; let the tires cool down first. Don't forget your spare and be sure your jack is in good condition.
- Check your owner's manual to find out what fuel octane rating your car's engine needs then buy it.
- Keep your tires inflated to the proper levels. Under-inflated tires make it harder for your car to move down the road, which means your engine uses more fuel to maintain speed.
- Lighten the load. Heavier vehicles use more fuel, so clean out unnecessary weight in the passenger compartment or trunk before you hit the road.
- Use the A/C sparingly. The air conditioner puts extra load on the engine forcing more fuel to be used.
- Keep your windows closed. Wide-open windows, especially at highway speeds, increase aerodynamic drag and the result is up to a 10% decrease in fuel economy.
- Avoid long idling. If you anticipate being stopped for more than one minute, shut off the car. Contrary to popular belief, restarting the car uses less fuel than letting it idle.
- Stay within posted speed limits. The faster you drive, the more fuel you use. For example, driving at 65 miles per hour (mph) rather than 55 mph, increases fuel consumption by 20 percent.
- Use cruise control. Using cruise control on highway trips can help you maintain a constant speed and, in most cases, reduce your fuel consumption.
- Keep your engine tuned. A fouled spark plug or plugged/restricted fuel injector can reduce fuel efficiency as much as 30 percent.
- Inspect the engine's belts regularly. Look for cracks or missing sections or segments. Worn belts will affect the engine performance.
- Have the fuel filter changed every 10,000 miles to prevent rust, dirt and other impurities from entering the fuel system.
- Change the transmission fluid and filter every 15,000 to 18,000 miles. This will protect the precision-crafted components of the transmission/transaxle.
- Inspect the suspension system regularly. This will extend the life of the vehicle's tires.
Prev Slide Next Slide

INSPECTIONS & EMISSIONS

hours

Contact us

B & S Automotive

Vehicle tips

ASSOCIATIONS

quick links

services

Newsletter signup

B & S Automotive